After receiving a new set of sleeves, let them rest for 24 hours after unpacking so that it adapts to the environment in the factory.

Store the sleeves in an upright standing position on the mat at a consistent temperature and humidity.

CDA forms a cushion to mount and demount the sleeves smoothly. Waiting approx. 20 seconds to allow this air to escape ensures proper mounting.

Allow the sleeves to dry as using a wet sleeve may cause the tape to not stick properly, resulting in substandard prints.

Avoiding silicon spray in the prepress department helps the tape stick better.

Avoid exerting excessive pressure towards the edges of the plate or tape while demounting it.

The positioning of the cutting knife in a slight angle on the tape ensures a tight fit.

Clean the sleeve before use to remove the dust particles as it can prevent proper adhesion of the tape.